If you’re looking for bulletproof Losi Tenacity (SCT, T & DB) parts, RPM has you covered. Their front & rear skid plates are designed to fit both the molded chassis version as well as the aluminum chassis version of the Tenacity.

Molded Chassis versions

One of the main breakage area of the molded Tenacity chassis is the area located just behind the front bulkhead mounting screws. The RPM skid plates hold the four bulkhead mounting screws with the two screws holding the steering mounting posts in place together, adding strength and durability to the entire front end of the chassis, helping to reduce that annoying breakage problem while adding some much needed abrasion resistance to the chassis.

Aluminum Chassis versions

A new aluminum chassis for the Tenacity SCT will cost you $55.99. So, we want to protect that chassis for as long as possible. What better way is there than a product specifically designed to reduce skid and abrasion resistance? RPM skid plates will not only increase the longevity of your valuable aluminum chassis, but they’ll also significantly reduce the number of scuffs and scratches it’ll receive since the skid plates are the lowest impact point on the chassis.

Both chassis versions

The RPM rear skid plate adds some much needed abrasion and wear protection. Whether you’re running a molded or an aluminum chassis version, no one wants to replace a chassis because it wore out. It’s much easier and less expensive to replace a skid plate such as these. Using the skid plate also allows less build-up of dirt and debris between the chassis and the lower rear bumper mount since the rear skid plate sits lower than the bumper mount.

RPM skid plates are made in the USA from an incredibly tough blend of engineering grade nylons for performance you can count on. Get yours today!

For more on RPM Products.